| |
Alarm/Immobiliser
-
D4800
For those of you who own
a car with factory fitted keyless entry either via a
separate remote control or a key-remote thin this is the
ideal product upgrade product. The D4800 is designed to
upgrade your keyless entry into a full function alarm/Immobiliser. Check out the features below.
FEATURES
-
Upgrades any
keyless entry system into a full alarm system.
-
Uses vehicles
OEM supplied remote controls.
-
Requires
basically only 3 connections for the identification of
arm/disarm.
-
Two trigger
inputs- for doors and bonnet and or boot.
-
Milli volt
sensing- (installer selectable)
-
User
retrievable diagnostics
- reports the last
three triggers in reverse order.
-
Automatic
fault isolation
- should a zone become
defective, the D4800 will isolate and ignore the
circuit responsible.
-
Intelligent
siren reset timer- meets AS/NZS 3749.1-1997
-
Output to
drive either horn or siren
-
False alarm
free glass breakage detector- (plug in)
-
Pulsed or
constant output- (Installer selectable)
-
Two circuits
of built in immobilization
-
Indicator
lights confirmation flash outputs- (2 On, 1
Off)
-
Confirmation
flashes- (installer removable).
-
Confirmation
siren/horn beeps- (Installer removable).
-
Bright red
flashing LED warning light.
-
Operating
voltage- +9VDC - +18VDC.
-
Operating
ambient temperature
- 300 C to + 50
C
-
Operating
current- < 15 mA.
-
Operating
field strength environment
-Up to 50 V/M (1 MHz
to 1000 MHz)
-
Load dump
protected
(70 Joules)
-
Polarity
independent
-
Options:
Plug in ultrasonic or microwave
detectors.
-
The D4800 is Certified to AS/NZS
3749.1-1997 Intruder Alarm Systems Road Vehicles.
-
As detailed in Test report EMC
000501.00 (Issued May 2000) Certificate No. 501.03
-
Note the d4800 will only qualify in
respect to as/nzs 3749.1:1999 provided that the
remote control supplied by the vehicle manufacturer
has rolling code and the vehicle is equipped with
Automatic engine immobilization as fitted by the
manufacturer.
Back To Products |
|
